Ambiance Fireplaces INT-200 Specifications download pdf (Page 8)

When installed, nailing flanges provide minimum 1/2” (13mm) clearance from fireplace sides.

CAUTION: NEVER PERMANENTLY REMOVE THESE ASSEMBLIES FROM FIREPLACE - THEY MUST BE SECURED IN PLACE REGARDLESS OF

FINISH MATERIAL USED.

FRAMING STUD

NAILING FLANGE

FRAMING STUD

1/2” (13mm)

CLEARANCE

STAND-OFF

FRONT VIEW

AS SHIPPED

NAILING FLANGES

INSTALLED

PREPARE THE FIREPLACE

HORIZONTAL VENT HEAT SHIELD INSTALLATION

1. Loosen, but do not remove center three screws at back of fireplace as shown.

2. Bend horizontal heat shield at perforation to a 45° angle. Slide (3) slots on

horizontal vent heat shield under loosened screws. Re-tighten screws.

Attach here.

NAILING FLANGE ASSEMBLY & INSTALLATION

1. Remove (4) nailing flanges from fireplace sides.

2. With the 1/2” (13mm) stand-offs on nailing flanges facing away from fireplace, align nailing flange with holes on outside corners of

fireplace. Secure with screws through slots in nailing flanges (additional screws provided in components packet).

3. Bend perforation on nailing flange until parallel with fireplace face. Do not bend toward fireplace face.

4. Position framing stud against 1/2” (13mm) stand-off (located on backside of nailing flange). Secure with nails or screws.

NOTE: Depending on facing material, tabs can be adjusted forward or back up to 1/2” (13mm).

NAILING FLANGE

PAGE 7

IMPORTANT: The horizontal vent heat shield must be installed when using a 45-degree elbow to horizontally position the vent system.

EXCEPTION: Corner installations

Figure 7a

1/2” (13mm)

CLEARANCE

STAND-OFF

TOP VIEW

Figure 7a

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

No comments

Ambiance Fireplaces INT-200 Specifications Page 8